Hitachi KP-FD30CL Security Camera User Manual


 
Preliminary
The KP-FD30 is equipped with the progressive full
frame RGB output of high frame rate( approx. 60
frame per second ). Optionally The KP-FD30CL
outputs Camera-Link. Both camera is equipped the
external synchronization(HD/VD), the external trigger
function, etc., it is suitable for the image-processing
equipment input.
Major feature
Suitable for the image-processing equipment input.
Small lightweight size, since adoption of multi-connector with one cable.
High resolution and high color  delity
By adoption of the progressive scan CCD image sensor and RGB primary
color mosaic  lters, the picture of high vertical resolution and high color
 delity can be acquired.
A new digital signal processor (DSP)
The clear picture of a high signal to noise ratio (S/N) is obtained by the new
digital signal processor (DSP) adoption which has improved luminance signal
processing, such as 5H enhancer processing.
CCD drive functions
.Preset electronic shutter ( settable 11 steps from 1/60 second to 1/50,000
second and
27 steps from 1/30 second to 8 second. )
.Variable electric shutter ( 1H steps from 1/60 second to Approx. 1/10,000
second )
.Auto electronic shutter[AES] ( from 1/60 second to approx. 1/50,000 second )
.Frame/ eld on demand ( one trigger and  xed shutter modes )
Output of NTSC system (2:1 interlace scan) (KP-FD30 only)
It can be set as the image output of NTSC system (2:1 interlace scan) by
switch change
VGA Progressive Scan CCD Color Camera
KP-FD30/KP-FD30CL
1 / 2-inch RGB primary color  lter progressive scan CCD image sensor RGB color camera
High frame rate 60 frame per second
Standard Optionally For OEM
Model KP-FD30 KP-FD30CL KP-FD30F KP-FD30USB
Output format Analog RGB Camera Link IEEEE-1394 USB2.0
Frame rate 60 frame per sec. 60 frame per sec. 30 frame per sec. 30 frame per sec.
Imaging device 1/2-inch progressive scan interline CCD
No. of effective pixels 659(H) × 494(V)
Unit cell size 9.9(H) x 9.9(V) m ( Square pixel )
Scanning area 7.48(H) × 6.15(V) mm
Color  lter R, G, B primary color mosaic  lters on chip
Scanning system
(Selectable by switch)
Progressive scan ( VGA mode )
2:1 interlace scan ( NTSC mode )
Frequency Horizontal: 31.468 kHz Vertical: 59.94 Hz
Sync system Internal / external ( HD/VD auto selection )
Internal sync output :HD/VD/SYNC 2 Vp-p/75 , Negative polarity
WE: 5 Vp-p, Negative
External sync input HD/VD 2 to 5 Vp-p, Negative polarity
EXT. Trigger input: Low 0 VDC, High 2 to 5 VDC
Video signal output RGB output (G on SYNC)
Y/C output ( Only at the NTSC mode )
VBS output ( Only at the NTSC mode)
S/N ( Y signal ) More than 50dB ( AGC, enhancer and gamma off )
Resolution
( Y signal at center )
Horizontal: 440 TV lines
Vertical: 480 TV lines ( VGA mode ) 350 TV lines ( NTSC mode )
Standard sensitivity 2,000 lx ( F5.6, 100IRE )
Minimum illumination 10 lx ( F1.4, AGC ON, 50IRE )
Sensitivity selection Gain Adjustable at AGC OFF and AGC Limit Gain
Electric shutter speed
PRESET
AES
VARIABLE
Selectable in 11 steps high spped shutter
OFF(1/60), 1/100, 1/250, 1/500, 1/1000, 1/2000, 1/4000
1/10000, 1/20000, 1/30000, 1/50000 second
: Approx. 1H steps from 1/60 second to 1/10,000 second
Selectable in 27 steps low speed shutter
OFF(1/60), 1/30, 1/15, 1/10, 1/7.5, 1/6, 1/5, 1/3.75, 1/3, 1/2.5, 1/2,
1/1.5, 1, 1.5, 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5, 6, 6.5, 7, 7.5, 8 second
From 1/60 second to approx. 1/50,000 second
( Response : SLOW, NORMAL, FAST )
Approx. 1H steps from 1/60 second to 1/10,000 second
Auto level ontrol [ALC]
( The auto level control system of AES, lens iris and AGC. )
AVERAGE / PEAK&AVERAGE / AREA
( Scanning area is selectable from 9 area. )
Auto-iris lens
outputs [DC/VIDEO*]
DC ( Iris control voltage input type lens, cable length over 150mm )
: Coupling coil impedance Damper : 1,150 ±10% , Drive : 190 ±10%
Power supply : 12 VDC, 60 mA
Note :. "VIDEO" is optionally.
White balance Selectable in 3 modes
Auto-tracking[ATW]:2,500K~6,000K
preset [AWC] : (2,500K~10,000K)
R/B gain manual control [MANUAL] (2,500K~10,000K)
Text display 24 alpha-numeric characters in one line (only KP-FD30)
Picture adjustment Modes and settings can be selected and adjusted from
on-screen menu (only KP-FD30)
Remote control Modes and settings can be selected and adjusted from PC
by RS-232C level,
Power supply 12 VDC ± 10 %
Approx.360 mA(KP-FD30) pprox.370mA(KP-FD30CL)
(Including 60mA for auto-iris lens )
Lens mount C/CS mount ( Frange-back adjustment )
Ambient temperature
Operating : -10 to +50 C, (+14 to +122 F) 30 to 80 %RH
Storage : -20 to +60
C
(-4 to +144 F), 20 to 90 %RH
Vibration endurance
68.6 m/s
2
( 10 to 200Hz, 30 minutes each on XYZ axes )
Shock endurance 490 m/s
2
( vertical, horizontal, once each face )
External dimensions
58(W) x 58(H) x 48(D) ( not including lens and protrusions )
Mass Approx.220g ( without lens )
Note : If operated continuously, be sure to use at less than +40 C(104 F) for long term stable performance.
Please inquire detailed speci cations of KP-FD30CL.
Main speci cations