Filter
Top Products
DATE/TIME Setting
31
button.
6. Press "F.FWD" or "REW" button as many times as may be required to select the
correct hour, and then press "STOP/EJECT" button.
7. Repeat step 6 to select minute and AM/PM.
8. After setting AM or PM, press "DATE/TIME" button to change the display and start
the internal clock. It is recommended that you press "DATE/TIME" button to match the
time signal.
9. Press "DATE/TIME" button after setting the clock. The display will change as follows
each time the button is pressed.
NOTE: The date/time graphics will be recorded whenever they appear in the viewfinder.
To correct date/time information after starting the date/time
1. Press and hold "DATE/TIME" button, and then press "STOP/EJECT" button. The
month starts flashing.
2. Correct the incorrect digit by using "F.FWD", "REW" and "STOP" buttons.
To correct date/time information during programming
Press "STOP/EJECT" button repeatedly until the digit that is incorrect flashes. Correct
the incorrect digit by using "F.FWD", "REW" and "STOP/EJECT" buttons.