Filter
Top Products
Chapter 5. Completing your installation
Perform the following steps to return complete your installation:
__ 1. Make sure that you have reinstalled all of the covers on the following
system components:
__ a. iSeries system unit.
__ b. All system expansion units.
DANGER
An electrical outlet that is not correctly wired could place hazardous voltage
on metal parts of the system or the products that attach to the system. It is the
customer’s responsibility to ensure that the outlet is correctly wired and
grounded to prevent an electrical shock. (RSFTD201)
Note: The fans may start, and system reference codes will appear when you plug
the power cord for your system unit. These actions are normal. They do not
indicate that your system unit is performing an initial program load (IPL).
__ 2. Plug the power cords for the following system components into electrical
outlets:
__ a. Your system unit.
__ b. All expansion units attached to the system.
__ c. The system unit console.
__ d. The system printer.
__ 3. Turn power on to each of the following system components by using the
associated power-on button:
__ a. The system printer (if present).
__ b. The system control console.
__ 4. Look at the Function/Data display on the control panel. See Appendix C,
“System unit control panel” on page 43 if you need information about your
control panel.
__ 5. Does 01 B V=S appear in the Function/Data display and OK is illuminated?
Note: If you are using Operations Console remote control panel, it may be
necessary to click Enter to verify IPL speed.
Yes No
↓ Do the following:
__ a. Press the Mode Select button until the Manual indicator (a
small hand) lights up.
__ b. Press the Increment/Decrement push button until 02 appears
in the Function/Data display.
__ c. Press the Enter push button on the control panel.
__ d. Press the Increment/Decrement push button until B appears
in the Function/Data display.
__ e. Press the Enter push button on the control panel.
__ f. Press the Increment/Decrement push button until S appears in
the Function/Data display
© Copyright IBM Corp. 2000, 2002 27