Filter
Top Products
63
IP INFORMATION
IP Address Enter an unused IP Address within the IP address range used on your LAN. If the IP
Address of your LAN is from the 192.168.2.0 to 192.168.2.250, you can set an
unused IP Address within that range for the Camera, for example: 192.168.2.250.
Subnet Mask The Subnet Mask field must match the subnet setting on your LAN. For example:
255.255.255.0.
Gateway The Gateway is used to forward frames to destinations in a different subnet on the Internet.
The Gateway setting must be the same as the gateway used by the PCs on your LAN.
DNS Server DNS Server (Domain Name Server) translates names to IP addresses. Set the same
DNS Server as the PCs on your LAN.
Video Port The Video Port is used to transmit or receive the video stream through to the network. The
default port setting is “4321”. If you want to view the video from the Camera, this port
setting should be correct.
Web Port This camera supports web connection, and assigns the default web port to 80. Since the
web server may use port 80, you can use a different port for the Camera. If you change
the web port from 80 to 8080, you must type http://192.168.2.3:8080 to connect to the
Camera through a web browser.
Apply When you finish the “IP Information”, click “Apply”.
CAMERA INFORMATION
Camera Name The default camera name is “IPCamera_MJPEG”. It is recommended to change to a
meaningful name for the Camera
Firmware Displays the current firmware version of the Camera.
Apply Once you complete fillng out the “Camera Information”, click “Apply”.
WEB CONNECTION AND SETUP