Filter
Top Products
2
PLACING SLIDES & NEGATIVES IN THE HOLDERS
1. Open the film holder
by lifting the tab on
the bottom.
2. Insert the slide(s) into
the slide slot(s) or lay
the negative over the
negative slot.
3. Close the film holder.
Be sure the latch and
sides of the holder are
securely in place.
Only push the holder
through the FILM
HOLDER SLOT in the
direction of the arrow (from right to left).*
* To change move to the next picture when using the Roll Film Holder, slide the film itself
through the holder (while the holder is inserted in FILM2SD's FILM HOLDER SLOT).
Note: If the image is scanned upside down or mirrored, you can also correct this by using the
FLIP or MIRROR buttons later.
Tip: To avoid laying a negative in the wrong direction (which will produce a mirror image), be
sure you can correctly read the serial numbers at the top of the negative when placing it in the
holder.
Slides Negatives
Negatives (Roll)