Filter
Top Products
54 EN
DUBBING
(cont.)
P
L
A
Y
O
F
F
DV cable
(optional)
Video unit equipped with
DV output connector
To DV OUT
To DV IN
Power Switch
Core filter
Core filter
VIDEO/DSC Switch
(GR-DVL557/DVL357only)
Lock Button
Dubbing From A Video Unit Equipped With
A DV Connector (Digital Dubbing)
[To use this camcorder as a recorder:
GR-DVL557/DVL357/DVL257 only]
1
Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV output
connector using a DV cable as shown in the
illustration.
2
Set “REC MODE” to “SP” or “LP” in the Menu Screen
depending on your preference (੬ pg. 50).
3
Set the VIDEO/DSC Switch to “VIDEO” (GR-
DVL557/DVL357 only), then turn the Power Switch
to “ ” while pressing down the Lock Button
located on the switch. Turn on the video unit’s power
and insert the appropriate cassettes in the camcorder
and the video unit.
4
Press the Recording Start/Stop Button on the
camcorder to engage the Record-Pause mode.
“
DV. IN
” appears on the screen.
5
Engage the video unit’s Play mode, then engage the
Still Playback mode when you have found a spot just
before the edit-in point.
6
Press the Recording Start/Stop Button on the
camcorder to engage the Record mode. rotates
on the screen. Engage the video unit’s Play mode.
7
To stop dubbing, press the Recording Star/Stop Button
on the camcorder so that stops rotating, then
engage the video unit’s Stop mode.
8
Repeat steps 5 through 7 for additional editing.
NOTES:
●
It is recommended to use the AC Adapter as the power supply instead of the battery pack (
੬
pg. 9).
●
If the remote control is used when both the player and recorder are JVC video units, both units will perform
the same operation. To prevent this from happening, press the buttons on both units.
●
If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so
that an unusual image is not dubbed.
●
Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this
occurs, turn off the power and make connections again.
●
When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.
●
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
“SOUND MODE” setting (
੬
pg. 47).
●
During Digital Dubbing, no signals are output from the video or audio connectors.