Filter
Top Products
EDITING
38 EN
MasterPage: Left
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if
any image or sound deterioration.
* GR-DX97/77/57/37 only
To use this camcorder as a player
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit equipped with
a DV input connector using a DV cable as shown in the
illustration.
3 Start playback on the camcorder. (੬ pg. 17)
4 At the point you want to start dubbing, start recording
on the video unit. (Refer to the video unit’s instruction
manual.)
5 To stop dubbing, stop recording on the video unit, then
stop playback on this camcorder.
NOTES:
● It is recommended to use the AC Adapter as the power
supply instead of the battery pack. (੬ pg. 11)
● If a blank portion or disturbed image is played back on the
player during dubbing, the dubbing may stop so that an
unusual image is not dubbed.
● Even though the DV cable is connected correctly,
sometimes the image may not appear in step 4. If this
occurs, turn off the power and make connections again.
● If “Playback Zoom” (੬ pg. 20) or “Playback Special Effects”
(੬ pg. 20) is attempted or SNAPSHOT is pressed during
playback, only the original playback image recorded on the
tape is output from the DV IN/OUT connector.
● When using a DV cable, be sure to use the optional
JVC VC-VDV204U DV cable.
To use this camcorder as a recorder (GR-DX97/77/57/
37 only)
1 Make sure all units are turned off.
2 Connect this camcorder to a video unit equipped with
a DV output connector using a DV cable as shown in the
illustration.
3 Set “REC MODE” to “SP” or “LP”. (੬ pg. 27, 28)
4 Set the camcorder’s Power Switch to “PLAY”.
5 Press the Recording Start/Stop Button to engage the
Record-Pause mode.
● The “” indication appears on the screen.
6 Start playback on the player.
7 At the point you want to start dubbing, press the
Recording Start/Stop Button to start dubbing. The
indication rotates.
8 Press the Recording Start/Stop Button again to stop
dubbing. The indication stops rotating.
NOTES:
● If no image is displayed on the LCD monitor, set “S/AV
INPUT” to “OFF”. (੬ pg. 27, 30)
● Digital Dubbing is performed in the sound mode recorded
on the original tape, regardless of the current “SOUND
MODE” setting. (੬ pg. 28)
Dubbing To Or From A Video Unit
Equipped With A DV Connector (Digital
Dubbing)
Core filter
To DV IN*/OUT
DV cable
(optional)
Video unit equipped with DV connector
To DV IN/OUT
DV. IN
GR-DX97PAL.book Page 38 Tuesday, January 6, 2004 12:44 PM