Filter
Top Products
14 EN
180°
90°
BRIGHT
–
–––––––
6
––– +
25
MIN
120MIN
3MIN
2MIN
MIN 119MIN
1MIN0MIN
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
●
Power (
੬
pg. 6)
●
Load A Cassette (
੬
pg. 13)
●
Recording Mode Setting (
੬
pg. 11)
●
Tape Length Setting (
੬
pg. 12)
●
Grip Adjustment (
੬
pg. 8)
●
Viewfinder Adjustment (
੬
pg. 8)
Shooting While Watching The Viewfinder
1
Make sure the LCD monitor is closed and locked
(GR-AXM231 only). Press in the tabs on the lens cap
to remove it. Set the Power Switch to “ ” or “ ”.
The power lamp lights and the camcorder enters the
Record-Standby mode. “PAUSE” is displayed in the
viewfinder.
2
Press the Recording Start/Stop Button. “ ” appears
in the viewfinder while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
Power Switch
BRIGHT Wheel
(GR-AXM231 only)
Recording Start/Stop Button
Tape remaining
time indicator
(Approximate)
(Now calculating)
(Blinking) (Blinking) (Blinking)
To Adjust The Brightness Of The LCD Monitor
.... rotate the BRIGHT Wheel until the bright
level indicator on the display moves and
the appropriate brightness is reached.
RECORDING
Basic Recording
Power Switch Position
: Suitable for standard recording using NO special effects or manual adjustments.
: Allows you to set recording functions using the menus for more creative capabilities.
OFF : Switches off the camcorder.
: Allows you to play back your recordings.
During shooting
Shooting While Watching The
LCD Monitor (GR-AXM231 only)
1
Make sure the LCD monitor is fully open. Press in the
tabs on the lens cap to remove it. Set the Power
Switch to “ ” or “ ”. The power
lamp lights and
the camcorder enters the Record-Standby mode.
“PAUSE” is displayed in the LCD monitor.
2
Tilt the LCD monitor upward/downward for best
viewability and press the Recording Start/Stop Button.
“ ” appears in the LCD monitor while recording is
in progress.
NOTE:
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, use the viewfinder instead.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.