Filter
Top Products
MasterPage: Heading0_Left
38 EN
TROUBLESHOOTING
If, after following the steps in the chart below, the
problem still exists, please consult your nearest
JVC dealer.
Power
● The power is not connected properly.
HConnect the AC Adapter securely. (੬ pg. 13)
● The battery pack is not attached firmly.
HDetach the battery pack once again and re-attach
it firmly. (੬ pg. 11)
● The battery is dead.
HReplace the dead battery with a fully charged
one. (੬ pg. 11)
Video Recording
● The tape’s erase protection tab is set to “SAVE”.
HSet the tape’s erase protection tab to “REC”.
(੬ pg. 16)
● “TAPE END” appears.
HReplace with new cassette. (੬ pg. 16)
● The cassette holder cover is open.
HClose the cassette holder cover.
● This is not a malfunction.
● This is not a malfunction.
● “DATE/TIME” is set to “OFF”.
HSet “DATE/TIME” to “ON”. (੬ pg. 22, 26)
● Certain Wipe/Fader effects, certain modes of
Program AE with special effects, “DIS” and other
functions that cannot be used together are
selected at the same time.
HRe-read the sections covering Wipe/Fader
effects, Program AE with special effects and
“DIS”. (੬ pg. 22, 24, 33, 34)
● 25X optical zoom is selected.
HSet “ZOOM” to “100X” or “800X”. (੬ pg. 23)
Video Playback
● Your TV has AV input terminals, but is not set to
its VIDEO mode.
HSet the TV to the mode or channel appropriate for
video playback. (੬ pg. 21)
● The cassette holder cover is open.
HClose the cassette holder cover. (੬ pg. 16)
HClean the video heads with an optional cleaning
cassette. (੬ pg. 44)
Advanced features
● Focus is set to the Manual mode.
HSet Focus to the Auto mode. (੬ pg. 29)
● The lens is dirty or covered with condensation.
HClean the lens and check the focus again.
(੬ pg. 42)
● The 5-Second mode is set to “Anim.” in MANUAL
Menu.
HSet “5S” to “5S” in MANUAL Menu.
(੬ pg. 22, 28)
● The Squeeze mode (SQUEEZE) is selected.
HDisengage the Squeeze (SQUEEZE) mode.
(੬ pg. 22, 24)
The camcorder is a microcomputer-controlled
device. External noise and interference (from a
TV, a radio, etc.) might prevent it from
functioning properly. In such cases, first
disconnect its power supply unit (battery pack,
AC Adapter, etc.) and wait a few minutes; and
then re-connect it and proceed as usual from
the beginning.
No power is supplied.
Recording cannot be performed.
When shooting a subject illuminated by
bright light, vertical lines appear.
When the screen is under direct sunlight
during shooting, the screen becomes red or
black for an instant.
During recording, the date/ time does not
appear.
The LCD monitor or viewfinder indications
blink.
Digital Zoom does not work.
The tape is moving, but there is no picture.
Blocks of noise appear during playback, or
there is no playback picture and the screen
becomes blue.
The focus does not adjust automatically.
In the 5-Second mode, recording ends
before 5 seconds have elapsed.
Snapshot mode cannot be used.
REFERENCES
GR-D239PAL.book Page 38 Friday, April 22, 2005 11:25 AM