JVC GR-D246 Digital Camera User Manual


 
EN 21
VIDEO PLAYBACK
MasterPage: Start_Right
VIDEO RECORDING & PLAYBACK
The detected blank portion may be located
between recorded scenes. Before you start
recording, make sure there is no recorded scene
after the blank portion.
A Black to S-VIDEO IN (Connect when your TV/
VCR has S-VIDEO IN and A/V input
connectors. In this case, it is not necessary to
connect the yellow video cable.)
B Yellow to VIDEO IN (Connect when your TV/
VCR has only A/V input connectors.)
C Red to AUDIO R IN**
D White to AUDIO L IN**
* If your VCR has a SCART connector, use the
provided cable adapter.
** Not required for watching still images only.
NOTE:
Set the video out select switch of the cable adapter
as required:
Y/C: When connecting to a TV or VCR which
accepts Y/C signals and uses an S-Video cable.
CVBS: When connecting to a TV or VCR which
does not accept Y/C signals and uses an audio/
video cable.
1 Make sure all units are turned off.
2 Connect the camcorder to a TV or VCR as
shown in the illustration.
If using a VCR, go to step 3.
If not, go to step 4.
3 Connect the VCR output to the TV input,
referring to your VCR’s instruction manual.
4 Turn on the camcorder, the VCR and the TV.
5 Set the VCR to its AUX input mode, and set
the TV to its VIDEO mode.
6 Start playback on the camcorder. (pg. 20)
To choose whether or not the following
displays appear on the connected TV
Date/Time
Set “DATE/TIME” to “AUTO”, “ON” or “OFF”.
(pg. 22, 27)
Time Code
Set “TIME CODE” to “ON” or “OFF”.
(pg. 22, 27)
Indications other than date/time and time code
Set “ON SCREEN” to “OFF”, “LCD” or “LCD/TV”.
(pg. 22, 27)
NOTES:
It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
(pg. 13)
To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder’s Power Switch to “A” or “M”, then set
your TV to the appropriate input mode.
Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
Connections To A TV Or VCR
2413
TV
VCR
Open the cover.
To AV
connector
To TV or VCR
“Y/C”/“CVBS”
Video Out Select
Switch
Cable
Adapter*
S/AV cable
(provided)
mark
GR-D246PAL.book Page 21 Tuesday, March 29, 2005 3:43 PM