Filter
Top Products
MasterPage: Advan_Heading0_Right
42 EN
Still images can be dubbed from a tape to a
memory card.
1 Load a cassette. (੬ pg. 16)
2 Load a memory card. (੬ pg. 17)
3 Set the VIDEO/MEMORY Switch to
“VIDEO”.
4 Set the Power Switch to “PLAY” while
pressing down the Lock Button located on the
switch.
5 Set “SNAP/SLOW” to “SNAP”. (੬ pg. 35)
6 Set “[T] ➝ [M] COPY” to “ON”. (੬ pg. 35)
7 Press 6 to start playback.
8 At the point you want to dub, press 6
again to engage Still Playback.
9 To dub the image, press SNAPSHOT.
●
The “ ” indication appears during dubbing.
NOTE:
To use Playback Special effects with a video
image you wish to dub, perform up to step 9 using
the remote control. (
੬ pg. 24)
Dubbing Still Images Recorded On
A Tape To A Memory Card
To use this camcorder as a player
1 Following the illustration, ੬ pg. 23,
“Connections To A TV Or VCR” , connect the
camcorder and the VCR’s input connectors.
2 Perform steps 1 - 6 (੬ pg. 23)
3 At the point you want to start dubbing, start
recording on the VCR. (Refer to the VCR’s
instruction manual.)
4 To stop dubbing, stop recording on the
VCR, then stop playback on the camcorder.
NOTES:
● It is recommended to use the AC Adapter as
the power supply instead of the battery
pack. (
੬ pg. 13)
● To choose whether or not the following displays
appear on the connected TV
•Date/time
Set “DATE/TIME” to “ON” or “OFF”
(
੬ pg. 35). Or, press DISPLAY on the remote
control to turn on/off the date indication.
•Time code
Set “TIME CODE” to “OFF” or “ON”
(
੬ pg. 35).
•Indications other than date/time and time code
Set “ON SCREEN” to “OFF”, “LCD” or “LCD/
TV” (੬ pg. 35).
Dubbing To A VCR
FEATURES FOR RECORDINGS EDITING
GR-D790US.book Page 42 Friday, December 15, 2006 9:26 AM