Filter
Top Products
26 EN
RECORDING
Advanced Features (cont.)
System Menu Explanations
: Factory-preset
Date/Time Menu Explanations
ON SCREEN OFF Keeps the camcorder's display from appearing on the connected TV
screen.
ON Makes the camcorder's display appear on screen when the
camcorder is connected to a TV.
DISPLAY ON Makes the date/time settings appear in the camcorder (੬ pg. 11).
OFF Keeps the date/time settings from appearing in the camcorder.
DATE/TIME Allows you to set the current date and time (੬ pg. 11).
PHOTO MODE Allows you to set the parameters for “FULL”, “FRAME”, “PIN-UP”, “MULTI 4” and
“MULTI 9” recording (੬ pg. 22).
TALLY ON The tally lamp comes on to signal the start of recording.
OFF The tally lamp remains off at all times.
WIND CUT OFF Disengages the function which cuts down on noise created by wind.
ON Helps cut down on noise created by wind.
•“ ” appears.
•The quality of the sound will change. This is normal.
SOUND MODE 32 kHz Enables recording of stereo sound on four separate channels, and is
recommended for use when performing audio dubbing with another
digital camcorder.
48 kHz Enables recording of stereo sound on two separate channels.
ID NUMBER This number is necessary when connecting the camcorder to a device such as a
computer using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting
is 07.
DEMO. MODE OFF Automatic demonstration will not take place.
ON Demonstrates certain functions such as Program AE with special
effects, etc., and can be used to confirm how these functions operate.
When “DEMO. MODE” is set to “ON” and the Recording Menu is
closed, demonstration starts.
NOTES:
●
If a tape is in the camcorder, the demonstration cannot be turned
on.
●
By turning off the camcorder, “DEMO. MODE” is set to “OFF”
automatically.