Filter
Top Products
EN5
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when
“DEMO. MODE” is set to “ON” (factory-preset).
Ⅲ Available when the Power Switch is set to “
” or “ ”
and no cassette is in the camcorder.
Ⅲ Performing any operation during the demonstration stops
the demonstration temporarily. If no operation is per-
formed for more than 1 minute after that, the demonstra-
tion will resume.
Ⅲ “DEMO. MODE” remains “ON” even if the camcorder
power is turned off.
Ⅲ To cancel Automatic Demonstration, set the Power
Switch to “
”, then press MENU/BRIGHT while the
demo is in progress. This takes you directly to the demo
mode’s Setting Menu (so you will not have to go through
the Menu Screen). Rotate MENU/BRIGHT to select
“OFF” and press it. The normal screen appears.
1
R
S
Z
G
T
I
D
R
E
O
O
A
A
D
E
E
C
U
O
I
L
M
C
T
N
M
N
L
N
O
A
U
M
D
Y
U
.
M
R
O
U
M
M
E
N
D
M
P
B
O
R
E
O
E
D
A
D
R
E
E
ME
O
N
N
U
MENU/BRIGHT Wheel
How To Attach The Core Filter
Attach the provided Core Filter to an optional S-Video cable, the PC connection cable provided with optional
HS-V14KIT software. The Core Filter reduces interference.
Release the
stoppers on both
ends of the Core
Filter.
Run the cable through the Core Filter, leaving approx.
3 cm of cable between the cable plug and the Core
Filter. Wind the cable once around the outside of the
Core Filter as shown in the illustration.
•Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
Close the Core Filter until it
clicks shut.
3 cm
Stopper
Ⅲ When connecting cables, attach the end with the Core Filter to the camcorder.
12 3
Wind once