JVC GY-HD111 Camcorder User Manual


 
22
CONTROLS, INDICATORS AND CONNECTORS
Indications on the LCD Monitor and in the Viewfinder (Cont’d)
•STATUS 1
In addition to the information on the STATUS 0 screen, this screen displays the following items.
STATUS 1 Screen
12
3
4
568
9
0
7
No. Item Contents
1 VIDEO FORMAT display Displays the currently selected video format.
Allows you to select the REC item on the VIDEO FORMAT menu screen. X See page 64.
You can switch this display ON/OFF using the FORMAT item on the LCD/VF [2/3] menu screen.
X See page 75.
2 Time Code (TC)/User’s Bits
(UB) indication
Indicates the time code (h:m:s:frame) or user’s bits data.
Whether or not to display this item is set with the TC/UB item on the LCD/VF [2/3] menu screen.
X See page 75.
Whether the time code or user’s bits should be shown is selected with the TC DISPLAY switch inside the
LCD door.
3 Remaining tape indication Remaining tape indication (displayed in 1-minute steps)
This indicator blinks when remaining tape time is equivalent to less than 3 minutes.
Whether or not to display this item is set with the TAPE REMAIN item on the LCD/VF [2/3] menu screen.
X See page 75.
* When inserting a brand-new tape, the remaining tape time is not indicated.
When the tape has been run, the indication will appear.
* The remaining tape indication is to be regarded only as a guide.
* When the unit is used at low temperatures, it may take a while before the indication of the remaining tape
time appears.
4 Voltage indication (Example) 7.0V: Indicates remaining battery level in 0.1V steps.
(Example) Time code TC 00 : 00 : 00 : 00
User’s bits UB FF EE DD 20
Colon (:) when non-drop frame mode
Dot (.) when drop frame mode