Filter
Top Products
EN5
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when “DEMO MODE” is
set to “ON” (factory-preset).
Ⅲ Available when the Power Switch is set to “
” or “ ” and
no cassette is in the camcorder.
Ⅲ Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for
more than 1 minute after that, the demonstration will resume.
Ⅲ “DEMO MODE” remains “ON” even if the camcorder power
is turned off.
Ⅲ To cancel Automatic Demonstration:
1. Set the Power Switch to “
” while pressing down the Lock
Button located on the switch and press the MENU wheel.
The Menu Screen appears.
2. Rotate the MENU wheel to select “
SYSTEM” and press
it. The SYSTEM Menu appears.
3. Rotate the MENU wheel to select “DEMO MODE” and
press it. The Sub Menu appears.
4. Rotate the MENU wheel to select “OFF” and press it.
5. Rotate the MENU wheel to select “
1
RETURN”, and press it
twice.
The normal screen appears.
MODEDEMO –
ON
OFF
MENU Wheel
Sub Menu
How To Attach Core Filter
Attach the provided Core Filter to an optional external microphone. Core Filter reduces interference.
Release the
stoppers on both
ends of the Core
Filter.
Run the cable through the Core Filter, leaving approx.
3 cm of cable between the cable plug and the Core
Filter. Wind the cable around the outside of the Core
Filter as shown in the illustration.
•Wind the cable so that it is not slack.
NOTE:
Take care not to damage the cable.
Close the Core Filter until it
clicks shut.
3 cm
Stopper
Ⅲ When connecting cables, attach the end with the Core Filter to the camcorder.
12 3
wind once