JVC GR-DVL300 Camcorder User Manual


 
EN45
1
2
3
4
5
6
7
8
––
T
T
I
O
M
T
E
A
I
L
N
:
C
O
D
~
~
~
~
~
~
~
~
E
O
0
U
0
T
:
:
0
0
M
ODE
PLAY
R.A.EDIT
ON/OFF
EFFECT
FADE/WIPE
EDIT IN/OUT
CANCEL
SELECT SCENES
4
Point the remote control at the camcorders remote
sensor. Press PLAY (
4
) and then press R.A.EDIT ON/
OFF on the remote control.
The Random Assemble Editing Menu appears.
5
If using a Fade/Wipe at the beginning of the scene,
press FADE/WIPE on the remote control.
Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
You cannot use a Picture Wipe/Dissolve at the
beginning of Programme 1.
6
At the beginning of the scene, press EDIT IN/OUT on
the remote control. The Edit-In position appears in
the Random Assemble Editing Menu.
7
At the end of the scene, press EDIT IN/OUT. The
Edit-Out position appears in the Random Assemble
Editing Menu.
8
If using a Fade/Wipe at the end of the scene, press
FADE/WIPE.
Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
If you select a Fade/Wipe effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
You cannot use a Picture Wipe/Dissolve at the end
of the last scene.
When you use Fade/Wipe effects, that time is
included in the total time (this does not apply to
Picture Wipe/Dissolve).
1
9
If using Playback Special Effects, press EFFECT
( pg. 42).
10
Repeat steps 6 through 9 to register additional scenes.
To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
If you are not using Fade/Wipe or Programme AE
with special effects, repeat steps 6 and 7 only.
NOTES:
When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between
them.
If the search time for an in-point exceeds 5 minutes, the recording decks Record-Standby mode will be
cancelled and editing will not take place.
If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in
the edited version.
Since time codes register time only as accurately as seconds, the time code total time may not match the
total programme time exactly.
Turning off the camcorders power erases all registered Edit-In and Edit-Out points.
If you select Sepia or Monotone mode from Programme AE with special effects, you cannot use the Dissolve
or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next
Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during
recording, then use the Dissolve or Black & White Fader during Random Assemble Editing.
It is not possible to use Fade/Wipe effects and Programme AE with special effects during Random Assemble
Editing using a DV cable.
Random Assemble
Editing Menu
Programme
Remote sensor
CONTINUED ON NEXT PAGE