JVC LYT0002-0M8B Camcorder User Manual


 
6 EN
GETTING STARTED
Power
This camcorder’s 3-way power supply system lets you
choose the most appropriate source of power.
NOTES:
No function is available without power supply.
Use only specified power supply.
Do not use provided power supply units with other
equipment.
CHARGING THE BATTERY PACK
SUPPLY POWER
1
Connect the charger’s AC power cord to a wall
outlet. The power indicator lights.
ATTACH BATTERY PACK
2
Align the marks and slide the battery pack in the
direction of the arrow until it locks in place.
The CHG. indicator lights.
DETACH BATTERY PACK
3
When charging is completed, the END indicator
lights. Slide the battery pack opposite the direction of
the arrow.
Approximate recording time (unit: min.)
USING THE BATTERY PACK
ATTACH BATTERY PACK
1
Hook its top end to the camcorder and push the
battery pack in until it locks in place.
DETACH BATTERY PACK
2
Slide BATT. RELEASE and pull out the battery pack.
BATT. PACK CHARGE DISCHARGE
BN-V12U approx. 1 hr. 10 min. approx.
3 hrs. 30 min.
BN-V22U approx. 2 hrs. 10 min. approx. 7 hrs.
BN-V25U approx. 2 hrs. 40 min. approx. 10 hrs.
BATT. LCD monitor on/ LCD monitor off/
PACK Viewfinder off Viewfinder on
GR-AXM30 GR-AXM20 GR-AXM30 GR-AXM20
BN-V12U 50 (35) 50 55 (35) 55
BN-V22U 110 (75) 110 120 (80) 120
BN-V25U 150 (100) 150 160 (105) 160
REFRESH indicatorREFRESH switch
To AC outlet
POWER
indicator
END
indicator
( ): when the light is on (GR-AXM30 only).
CHG. (charge) indicator
Marks
**REFRESH
The AC power adapter features a REFRESH
function that allows you to fully discharge
the battery pack before recharging.
Perform the REFRESH function after no
less than 5 chargings.
To discharge the battery . . .
.....attach the battery pack to the adapter
as shown in the above illustration.
Then push REFRESH. The REFRESH
indicator lights when discharging
starts, and goes out when discharging
is complete.
ATTENTION:
Before detaching the power source,
make sure that the camcorder’s power
is turned off. Failure to do so can result
in a camcorder malfunction.
1
1
2
BATT. RELEASE
Hook on.
Push in.