JVC LYT0002-0W3A Camcorder User Manual


 
EN 13
SP SP LP
OFF
P
L
A
Y
A
M
5S
REC MODE
WIDE MODE OFF
AGC
AUTO
20X
SP
ZOOM
DIS
GAIN UP
FLASH
TO DATE / TIME MENU
TO SYSTEM MENU
4
END
ON
REC MODE
WIDE MODE OFF
AGC
AUTO
20X
SP
ZOOM
DIS
GAIN UP
FLASH
TO DATE / TIME MENU
TO SYSTEM MENU
4
END
ON
Recording Mode Setting
Set depending on your preference.
1
SELECT OPERATION MODE
Set the Power Dial to “
M
” while pressing
down the lock button located on the dial.
2
OPEN LCD MONITOR
Open the LCD monitor fully.
The power lamp comes on and the camcorder
is turned on.
•The LCD monitor turns on/off automatically
when it is opened/closed at approx. 90 degrees
while the Power Dial is set to any operation
mode (except “OFF”).
•The LCD monitor can be tilted upward up to
180 degrees and downward up to 90 degrees.
3
ACCESS RECORDING MENU
Press MENU. The Recording Menu appears.
4
SET RECORDING MODE
First move the pointer and highlight bar to
“REC MODE” by rotating the Select Dial. Press
the Select Dial and the parameter “SP” or “LP”
is highlighted. Select “SP” or “LP” by rotating
the Select Dial. Press the Select Dial to exit
from the Recording Menu.
•Insert Editing or Audio Dubbing is impossible
on a tape recorded in the LP mode.
•“LP” (Long Play) is more economical,
recording at 2/3 the speed of “SP” (Standard
Play).
NOTES:
If the recording mode is switched during
recording, the playback picture will be blurred at
the switching point.
It is recommended that tapes recorded in the LP
mode on this camcorder be played back on this
camcorder.
During playback of a tape recorded on another
camcorder, blocks of noise may appear or there
may be momentary pauses in the sound.
Recording Menu
Recording mode indicator
LCD monitor
Lock button
Power dial
Power lamp
MENU button
Select Dial