JVC LYT0610-001A Camcorder User Manual


 
56 EN
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
39.
An error indication
(E01 — E06) appears.
40.
The charger indicator on
the AC Power Adapter/
Charger does not light.
41.
Picture does not appear on
the LCD monitor.
42.
When the image is printed
from the printer, a black
bar appears at the bottom
of the screen.
43.
When the camcorder is
connected via the DV
connector, the camcorder
does not operate.
39.
•A malfunction of some kind
has occurred. In this case
the camcorder’s functions
become unusable.
40.
•The temperature of the
battery is extremely high/low.
•Charging is difficult in
places subject to extremely
high/low temperatures.
41.
•The lens cap is attached.
•The LCD monitor's
brightness setting is too
dark.
42.
•This is not a malfunction.
43.
•The DV cable was plugged/
unplugged with power
turned on.
39.
•Remove the power supply
(battery pack, etc.) and wait a
few minutes for the indication
to clear. When it does, you
can resume using the
camcorder.
If the indication remains even
though you repeat the above
two or three times, please
consult your nearest JVC
dealer.
40.
•To protect the battery, it is
recommended to charge it
in places with a temperature
of 10°C to 35°C ( pg. 63).
41.
•Remove the lens cap
( pg. 12).
•Adjust the brightness of the
LCD monitor ( pg. 12).
•If the monitor is tilted
upward 180 degrees, open
the monitor fully ( pg. 13).
42.
•By recording with “DIS”
activated ( pg. 22) this
can be avoided.
43.
•Turn the camcorder’s power
off and on again, then
operate it.
TROUBLESHOOTING
(cont.)