Filter
Top Products
9
B
Press the video recording start/stop button
or the still image lever to start recording.
C
When you have finished recording, press
and hold the power button for more than 2
seconds to turn off the camera.
z The camera’s power lamp goes out and the
monitor turns off.
If there is a need to detach immediately:
A
Submerge the marine case in fresh water
and shake the marine case in the upward,
downward, left and right directions for at
least 10 times, followed by rinsing it.
B
Remove the marine case and wipe off
water droplets on the case surface using a
dry towel.
C
Face the front glass of the marine case
upwards, and open the buckles to remove
the camera, while paying attention not to
let water droplets at O-ring or buckles
enter the case.
D
Upon removing the camera, close the
marine case again while paying attention
not to allow water droplets enter the case,
followed by tightening all the buckles.
¹ Always perform maintenance on the
marine case after using. (A Pg. 10)
If there is no need to detach immediately:
Perform maintenance on the marine case.
(A Pg. 10)
Zooming
(Tele)
Still image lever
Shoot still images.
Video recording start/stop button
Start/stop the video recording.
Zooming
(Wide)
Detaching the camera
WR-MG250_EN.book Page 9 Thursday, June 4, 2009 11:09 AM