Filter
Top Products
KiWi ClickDiscs
Disassembly
1) The Rotator Base
is held together with a
recessed set screw which is
located at the zero degree
position on the barrel. Use
the set screw wrench lo-
cated in the blue accessory
pouch and loosen the set
screw (do not remove) by
turning several revolutions
counter-clockwise.
2) With the set screw
loosened, remove the axle
by pulling up on the knob
which contains the bubble
level.
3) The axle has a thin
plastic washer. This washer
should always go between
the knob of the axle and
the horizontal plate. Leave
the plastic washer on the
axle.
4) You can remove the
ClickDisc from its cavity
in the top of the indexing
barrel by pulling up on the
tab of the ClickDisc.
How to install and remove ClickDisc indexing discs
3
Barrel w/ClickDisc
Installed
Set Screw Wrench in Barrel
Rotator Base Assembly
ClickDisc Accessory Pouch with 6
ClickDiscs and Set Screw Wrench