Filter
Top Products
Page - 6
Chapter 4
Using the QuickPan™
ADJUSTING THE SPRING FORCE OF THE PLUNGER
The dark colored adjusting screw which protrudes from the end of the
plunger is used to vary the force of the spring plunger. This adjustment is
typically used to provide more force when the plunger is moved towards the
center of the detent. In general, the closer the plunger is to the center of the
wheel, the more force is required in order to achieve a satisfactory detent
action. You can also adjust the force simply to correspond to your personal
preference.
You can tighten or loosen the adjusting screw when the plunger is installed
or removed from the unit, as shown below.