Filter
Top Products
KAMERA WERK DRESDEN GmbH
Page 6 of 15
Attaching the Camera Strap
Thread the camera strap in the lug (8).
Inserting the Batteries
NOBLEX PRO cameras require 4 batteries AAA (RO3/UM4/LR) 1,5V. Please use high-quality alkaline
batteries, of course, with items ‚Photo/Audio‘, ‚Photo‘ or ‚Power‘. When inserting the batteries follow
these instructions:
1. Open the battery compartment cover (24) by pressing the
upper half of the cover slightly and push it upwards.
2. Open up the battery compartment cover (24).
3. Insert the new batteries. Pay attention to the right polarity
and position of the strips for removing the batteries.
4. Lift the battery compartment cover (24) down.
5. Close the cover by pressing the lower half of the cover
slightly and push it downwards at the same time until it is
engaged.
Please note
Never use batteries of different types and do not mix old batteries with new ones. Do not use
rechargeable batteries. If you do not use your camera for an extended time, remove the batteries for
this time.
Inserting and removing the film
NOBLEX PRO cameras require 120 roll film. To insert and change the film please follow these
instructions:
Inserting the film (NOBLEX PRO 150)
1. Turn the camera off at the ON/OFF switch (10).
2. Advance the winding disk (5) until the counter
(5a) reaches position »5«. (If necessary, press
the shutter release button (4) to advance to the
position »5«.)
3. Unlock the camera back (9) and open it.
4. Insert the film spool into the left-hand spring-
loaded compartment (14).
5. Insert the empty film spool into the right-hand
compartment (18). The spool must engage in the
upper catch (20).
6. Thread the tongue of the paper lead into the
take-up spool.
7. Turn the winding disk (5) until the double arrow
on the protective paper of the film is opposite the
red dot on the camera film guide (16). pay
attention to insure a tight winding of the film.
8. Close the camera back and lock it (9).
9. Press the start button (5b). The counter is
released with that. Remark: At older models the
start key (5b) isn't available yet. In this case the
shutter release button (4) has to be pushed.
10. Advance the winding disk (5) in the direction of
the arrow until it stops. The film counter should
be at the number 1. To take a picture turn the
camera on at the ON/OFF switch (10) and press
the shutter release button (4).