Filter
Top Products
1918
“Beep”
“Beep,
beep”
Card access LED
Caution LED
5. Press the shutter release
button to take the picture.
1 Lightly depress the shutter
button halfway to begin
focusing; the focus mark will
light and the electronic beep
will be heard when focus is
locked.
Turning the LCD monitor off will
help conserve battery power.
Turning LCD monitor OFF (page 76)
1. Set the mode select lever to
“
”, then press the
“POWER” button to turn power
ON.
2. Press the “DISPLAY” button to
turn off the LCD monitor.
3. Hold the camera steadily as
shown to prevent camera
shake.
¶ See <Hints for Holding the Camera
Steady> on page 14.
Using the optical
viewfinder to compose
your picture.
4. Look through the optical
viewfinder while composing
your image.
Press the “T” button to enlarge
the subject, and the “W” button to
reduce the size of the subject.
<Precaution when using the
optical viewfinder>
When using the optical
viewfinder, take note of the
distance to your subject. As
distance to the subject
decreases, parallax (the
difference between what you
see in the viewfinder and the
actual image recorded through
the lens) increases. When
accurate subject composition
is required, use the LCD
monitor to take your pictures.
¶ Parallax: see page 25.
Using the Optical Viewfinder
¶ Your next picture can be taken
when the caution LED stops
flashing.
WT WT
2 Press down further on the
shutter release button to take
the picture; recording of the
image begins when the
electronic beep sound.
3 The caution LED and card
access LED will light while the
camera is writing image data to
the memory card.
2001.7.6, 6:07 PMPage 18-19