Filter
Top Products
NOTES: (continued)
• Remove your battery from the camcorder, camera or charger module
after use. These devices will continue to drain a small current from
your battery even if they are turned off.
• All batteries will naturally self-discharge over time, even if they are not
in use. For best performance, be sure to recharge your battery on the
same day or the day before you plan to use it.
CAUTIONS:
• Always unplug the power adapter from the power source, and from
the camcorder/camera when not in use.
• Do not use if wires become frayed or damaged, or plug is broken.
• Do not leave the battery in the charger module for prolonged periods
after reaching full charge.
• Use only the AC power adapter included in the package with the
charger module.
• Do not store, place or use any part of the OmniSource Power System
where it could come into contact with water or moisture.
• Do not use under direct sunlight or in hot environments (over 100 ºF /
38 ºC) as overheating may occur.
• Do not short-circuit the metal contacts of the power adapters, the
charger module or any battery.
• No user serviceable parts inside. Do not attempt to repair,
disassemble or modify any part of the OmniSource Power System.
Doing so will void warranty and may cause damage or personal
injury.
AC POWER ADAPTER SPECIFICATIONS:
3.6 Volt Units
Input: 100-240VAC / 50-60Hz
Output: 5VDC / 2A
7.2 Volt Units
Input: 100-240VAC / 50-60Hz
Output: 9VDC / 1.33A
Charger Modules for 3.6 Volt Units
Output: 4.2VDC / 1A max. (800-600mA typ.)
Charge Times (approx.) - 1200mAh – 135 min.
Charger Modules for 7.2 Volt Units
Output: 8.4VDC / 1A max. (800-600mA typ.)
Charge Times (approx.) - 650 mAh – 82 min. / 1200mAh – 117 min.
LIMITED WARRANTY:
This OmniSource product is warranted to be free of manufacturing
defects for 1 year from the original date of purchase. If, during the
warranty period, any part fails to function properly under normal use
because of manufacturing defects or workmanship, it will be repaired at
no charge for parts and labor or, at our option, the product will be
replaced. The following is excluded: damages from delay or loss of use
of equipment, or damaged batteries, malfunctions resulting from misuse,
tampering, unauthorized repairs, modifications, or accident. To obtain
warranty service, package the unit and its accessories carefully using
ample padding material to prevent damage in transit and ship it prepaid
and insured to:
Lenmar Enterprises, Inc.
4035 Via Pescador
Camarillo, CA 93012
When sending in product for service, your package should include
evidence of date and place of purchase. Enclose $10.00 for shipping and
handling for addresses in the U.S. and $15.50 in Canada. For outside the
U.S. and Canada, freight will vary depending upon ship to address.
For further information contact:
Lenmar Enterprises, Inc.
Web Site: www.lenmar.com