Filter
Top Products
4
iCAM4000 Installation
206.4
181.6
.841 4
011
HOLE
HOLE
HOLE
HOLE
HOLE
HOLE
HOLE
.62 7
551
210
Dimensions and Screw Holes on the Rear Enclosure
68.5
25 43.5
8
9
.841 4
42.9
Wall
Rotation Part with Front Enclosure Rear Enclosure
Dimensions of iCAM4000 (mm unit)
1. Remove the two security screws (use included security bit wrench) from the bottom of the iCAM
2. While gently pulling the cover upward on the back plate, pull forward.
3. Position the iCAM back plate on the desired wall near the secured door and mark the holes as the figure below
illustrates. The recommended height from the floor to bottom of unit is 142cm (56”), however the installation
height can be adjusted depending on average user height.