Filter
Top Products
Before you begin the installation, read all instructions.
Legal Warning
Certain uses of security camera
products and audio devices, such as
employee monitoring, surreptitious
viewing and recording of images and/or
audio, or the use, publication or
distribution of image and/or audio
recordings, are prohibited or restricted
by country, state and local laws.
Be sure to comply with the laws in your
country, state, and locality when using
Logitech Alert products and services.
1) Be sure that Logitech Alert Commander sotware is running on the PC
before beginning installation of camera.
• Shortly after connecting, your camera will appear in Alert Commander software. You can now move the camera to its desired location.
1 Logitech Outdoor Camera
2 Camera power supply
3 Power supply cable (yellow tips)
4 Mounting accessories
5 microSD™ card adapter
6 System Requirements Guide
Getting started with
Logitech
®
Alert
™
700e
Add-On Camera
!
Run Logitech Alert Commander
Logitech Alert Master System required.
!
1
2 3
4
5
6
2
Plug in Your Camera
When prompted to connect your camera:
1) Unscrew the hatch from the back of the camera and lift.
1a) Plug the yellow cable connector into the port.
1b) Screw the hatch firmly in place.
2) Unscrew the hatch from the power supply.
2a) Plug the yellow cable into the power supply port.
2b) Screw the hatch firmly in place.
2c) Mount the power supply unit to the wall.
2d) Plug the power connector into the plug slider and plug the power supply into an
outlet.
Wall/Ceiling Mounting Instructions
The wall mount allows you to easily fasten your camera to a wall, post,
overhang, or other surface.
1) Start by pre-drilling holes into the base surface and then fastening the
mouting base with the included screws.
2) Assemble the mounting arm and attach it to the base.
3) Attach the camera to the mounting arm.
1
1a 1b
2
2a
2b
2c
2d
1
2
3
or
!
RECOMMENDATION:
Mount the Outdoor Camera under an eave or
other overhang so that it is not exposed to direct
sunlight.
1
Power Supply Install Note
The power supply unit is weatherproof and can be installed outdoors. Use these tips to
ensure reliable power supply usage. Make sure the outdoor outlet is weatherproof. Do
NOT place on the ground.
1) Do NOT plug the power supply into a surge protector or power strip as they
interfere with the cameras. Surge protectors are built-in to the power supply and
protect the cameras.
2) Do NOT plug the power supply into the wall so that it lays horizontally or flat.
3) Do NOT mount the power supply upside down. Keep the cable connector port on
the bottom.
3
4
1
4) Avoid direct sunlight.
2
!
CAUTION: If left in sunlight, surface may be hot to the touch.
Quick-start
guide
Logitech
Alert
™
700e/750e
System Requirements
& Support Guide