Filter
Top Products
®
Page 5 www.midlandradio.com
BA
TTERY INSTALLATION
Your LXT110/80 Series radio operates with 3 AAA alkaline batteries or a NiMH
rechargeable battery. The belt clip should be removed to ease installation or
removal of the batteries.
To install the batteries:
1. With the back of the radio facing you, remove the belt clip (see diagram
below) for easy access, then remove the Battery Cover by pressing down on
the top center and sliding it down from the radio.
2. Insert 3 AAA batteries observing the polarity as shown on the Battery
Compartment. Installing the batteries incorrectly will prevent the unit from
operating or may damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the belt clip,
making sure it locks into place.
BATTERY
COMPARTMENT
BATTERY
COMPARTMENT
COVER
Press here and
push down to open
Model LXT110/80
BELT CLIP
LOCK TAB
BELT CLIP
LATCH
CHARGING THE BATTERY
Your LXT110/80 Series is equipped for using an rechargeable NiMH battery
which can be recharged by inserting the AC adapter into the radio charge jack.
Initial charge time is 24 hours. Charge time is about 12 hours thereafter. For
maximum battery life, we recommend charging the battery when the low battery
icon comes on. Remove the radios from the charger when the charge time
expires.
1. Only use our NiMH battery.
2. Do not attempt to charge alkaline batteries or any batteries or battery
packs other than the one indicated in the manual. This may cause
leakage and damage to the radio.
3. For long term storage of the radio, turn the radio OFF and remove the
batteries from the radio.
EXTERNAL SPEAKER/MICR
OPHONE JACK
To use an optional speaker / microphone or headset:
l Insert the plug(s) into the SPK/MIC jacks
l Place the earbud into your ear, and adjust the mic into your
desired position.
!
SPK
MIC
CHG