Miller Camera Support 25 Camcorder Accessories User Manual


 
Illumination Button
Retaining Screw
Battery
Battery Door
The Arrow 25 Fluid Head offers high quality surface coatings,
dust and moisture seals. Miller recommends keeping the
Fluid Head clean at all times by using soft brushes and lint
free cloth to wipe over the surfaces.
Do not immerse the Fluid Head in any liquid.
Do not use stiff brushes, abrasives, harsh detergents and
solvents.
Battery Replacement
The Arrow 25 Fluid Head uses a single GP23A type - 12 Volt
battery for Illumination. Miller recommends the following
batteries to provide long life performance – Duracell MN21/23,
Eveready A23 or Vinnic L1028.
Using a Phillips Head #1 screw driver, remove the two
RETAINING SCREWs, BATTERY DOOR and the old battery.
Insert the new battery as shown in figure 7.
Insert the tab on the BATTERY DOOR into the body first then
align the two screw holes and tighten the screws snugly.
Maintenance
Fig. 8
9