Nikon 13303 Digital Camera User Manual


 
24
D Shooting in Live View Mode
Although they will not appear in the final picture, distortion may be visible in the monitor if
the camera is panned horizontally or an object moves at high speed through frame.
Bright
light sources may leave after-images in the monitor when the camera is panned.
Bright
spots may also appear.
Flicker and banding visible in the monitor under fluorescent,
mercury vapor, or sodium lamps can be reduced using Flicker reduction (0 55), although
they may still be visible in the final photograph at some shutter speeds.
When shooting in
live view mode, avoid pointing the camera at the sun or other strong light sources.
Failure to
observe this precaution could result in damage to the camera’s internal circuitry.
Live view ends automatically when the monitor is closed (closing the monitor does not end
live view on televisions or other external displays).
Live view may end automatically to prevent damage to the camera’s internal circuits; exit live
view when the camera is not in use.
Note that the temperature of the camera’s internal
circuits may rise and noise (bright spots, randomly-spaced bright pixels, or fog) may be
displayed in the following instances (the camera may also become noticeably warm, but this
does not indicate a malfunction):
The ambient temperature is high
The camera has been used for extended periods in live view or to record movies
The camera has been used in continuous release mode for extended periods
If live view does not start when you attempt to start live view, wait for the internal circuits to
cool and then try again.
D The Count Down Display
A count down will be displayed 30 s before live view ends automatically (the timer turns red
5 s before the auto off timer expires (0 55) or if live view is about to end to protect the
internal circuits). Depending on shooting conditions, the timer may appear immediately
when live view is selected.