Filter
Top Products
•Film is completely rewound when the frame counter shows blinking “E” in
the LCD panel and viewfinder. (E appears without blinking when the
exposure meter is off.) Make sure the film is completely rewound (E is
blinking in the LCD panel and viewfinder), open the camera back away
from sunlight and remove the film cartridge by tilting it to one side.
2928
Confirm Indica
Confirm Indica
tions in
tions in
Viewfinder and Release Shutter
Viewfinder and Release Shutter
7
7.1
7.2
7.3
Focus, shutter speed and aperture can be confirmed in the viewfinder. If any
other warning indications appear, see page 101.
When you reach the end of the film roll, the film starts to rewind automatically.
For mid-roll rewind, see page 36.
For self-timer operation, see page 68.
When the camera back is opened before the film is completely rewound
(before E blinks), warning indication (blinking o–– and frame counter) appears
in the LCD panel and viewfinder. Refer to page 103 for troubleshooting.
Check points
BASIC OPERATION
Confirm that / (in-focus
indicator) appears in the
viewfinder, then slowly, fully
depress the shutter release
button. Camera automatically
tracks subject that has been
moving (page 88).
Confirm that focus indicator / appears and slowly
depress the shutter release button.
Confirm indications in the viewfinder while lightly
pressing the shutter release button. (Shutter speed
and aperture are shown in 1/2 steps.)
•When the subject is dark or the shutter speed is slower than 1/60 sec.,
use the built-in Speedlight to avoid picture blur (page 30).
•If any warning indications appear in the LCD panel or viewfinder, see
page 101.
•After shutter is released, the film automatically advances to the next
frame and the next shot can be taken.
Film starts to rewind automatically when film reaches
the end of the roll.
•o––, o– and then o appear in the LCD panel and viewfinder during film
rewind and the frame counter counts down until rewind is complete.
•Pictures taken on frames beyond the indicated number of the exposures
for the film roll may be discarded in the process of developing.
c 1: Film rewind can be changed not to start automatically when the
end of a film roll is reached (page 71).
c 13: High-speed film rewind is normally executed. This film rewind can
be changed to quiet film rewind (page 74).
7.4
Confirm that film is completely rewound, then
remove film cartridge.
F80 (E)-Thailand 02.12.27 5:20 PM Page 28