Filter
Top Products
79
n
This section lists the error messages that appear in the display.
Error Messages
Message Solution
(Shutter-speed or
aperture display flashes)
If the subject is too bright, lower ISO sensitiv-
ity or choose a faster shutter speed or smaller
aperture (higher f-number).
If the subject is too dark, raise ISO sensitivity,
use the built-in flash, or choose a slower
shutter speed or larger aperture (lower f-
number).
Keeping the zoom ring
button pressed, rotate the
zoom ring to extend the
lens.
A lens with a retractable lens barrel button is
attached with the lens barrel retracted. Press
the retractable lens barrel button and rotate
the zoom ring to extend the lens.
Check lens. Pictures can
only be taken when a lens
is attached.
Attach a lens.
Start-up error. Turn the
camera off and then on
again.
Turn the camera off, remove and replace the
battery, and then turn the camera on.
The clock has been reset. Set the camera clock.
No memory card.
Turn the camera off and confirm that the
card is correctly inserted.
This memory card is not
formatted. Format the
memory card?
Select Ye s to format the card, or turn the
camera off and insert another memory card.
Memory card is locked
(write protected).
Turn the camera off and slide the card write-
protect switch to the “write” position.
Memory card is full.
• You may be able to record additional
images if you reduce image quality or size.
• Delete unwanted images.
• Insert another memory card.
This memory card cannot
be used. Card may be
damaged; insert a
different card.
• Use an approved card.
• Format the card (0 17). If the problem per-
sists, the card may be damaged. Contact a
Nikon-authorized service representative.
• Insert a new memory card.