Filter
Top Products
Using the Nokia Image Frame
9
• SENDING AN IMAGE FROM THE NOKIA
IMAGE FRAME
When the power is switched on, select the image you want to send on
the display of the Nokia Image Frame.
1
If needed, activate the IR port of the device to which you want to
send an image.
2
Direct the IR ports of the Nokia Image Frame and the receiving
compatible device toward each other, and ensure that there are no
obstructions between the devices. The maximum allowed distance
is up to 4.9 ft (1.5 m) and the transmission angle 15
o
.
3
Press and to send the image. The icon blinks while
the Nokia Image Frame attempts to establish a connection to the
receiving device. During the image transfer the icon stops
blinking. When the image is successfully sent, the Nokia Image
Frame displays the icon.
• RECEIVING IMAGES WITH THE NOKIA
IMAGE FRAME
When the power is switched on, the Nokia Image Frame can receive
images. Note that the Nokia Image Frame converts the received images to
display them. For more information, see “Image format” on page 3.
The image receiving procedure differs depending on the sending device.
If the sending device can send images over IR, you can send the selected
images from the device while the Nokia Image Frame is in the passive
IR reception mode. If image sending cannot be activated from the sending
device, the Nokia Image Frame can pull all the images from the sending
device’s default image folder using the active IR reception mode.
RECEIVING IMAGES OVER IR:
1
If you want the images in the Nokia Image Frame to be in a certain
order, press briefly or to scroll to the image after which you
want to store the new images.