Filter
Top Products
13
Charging the Battery Using the Battery Charger (COOLPIX S610)
First Steps
The following chart explains CHARGE lamp status.
3 Unplug the charger.
Remove the battery and unplug the charger.
B Notes on the Battery Charger
• The supplied battery charger is for use only with a Rechargeable Li-ion Battery EN-EL12. Do not use
with incompatible batteries.
• Be sure to read and follow the warnings for the battery charger on page iii before using the battery
charger.
• Be sure to read the section, “The Battery” (A 119), thoroughly before use.
C Notes on AC Power Supply
• To power the camera continuously for extended periods, use the AC Adapter EH-63 (available
separately from Nikon) (A116). Do not, under any circumstances, use another make or model of
AC adapter. Failure to observe this precaution could result in overheating or in damage to the
camera.
• If you are using the COOLPIX S610, the battery cannot be charged by inserting it into the camera
and connecting the AC adapter. The AC adapter and the supplied audio/video cable or USB cable
cannot be used at the same time.
CHARGE lamp Description
Blinks Battery charging.
On Battery fully charged.
Flickers
The battery is not inserted correctly. Remove the battery and
reinsert it into the battery charger so that the battery is lying flat.
• Charge the battery indoors with an ambient temperature of
5 °C to 35 °C (41 °F to 95 °F) before use.
• The battery is faulty. Unplug the charger immediately and stop
charging the battery. Bring the battery and charger to a Nikon-
authorized service representative for inspection.