Filter
Top Products
7
8
.Dress extra cable into the hole
(or wall box if used) and position the
camera, starting at the top onto the
plastic back frame.
9
.Fully seat the camera into the back
f
rame and secure the camera with 4mm
camera attachment screw (supplied)
thru the
bottom of the back frame and camera.
Important: If camera is exposed to
outside elements, caulk should be
added to the top and sides of the
camera at the wall surface. Do not
caulk bottom surface.
Operational Checkout
Refer to the instructions provided with NuTone models
VSM4SK, or VSUC4SK.
Camera Volume Adjustment
The VSC4S door camera is provided with a volume level
adjustment set screw. The adjustment has been pre-set at
the factory to provide the optimal volume level at the door
camera. The volume level can be adjusted if your specific
application requires the level to be either increased or
decreased. Insert a jeweler’s screwdriver into the small hole
that is shown in the camera illustration. Rotate the small set
screw to adjust the volume level.
Important: Do not use excessive force to rotate the screw.
Damage could occur to the camera, and loss of audio may
result. Use extreme caution when making the adjustment. Do
not use a screwdriver that is too big for the application.
VSC4S
Volume Adjustment
Camera Lens Manual Adjustment
T
he VSC4S door camera is provided with a manual camera
lens adjustment. The adjustment can be used to fine tune
the angle of the camera lens to compensate for installations
that are not directly in line to the viewing area. The adjust-
ment is located on the back of the camera, as shown in the
camera illustration. Move the adjustment control upward to
lower the camera lens. Move the adjustment control down-
w
ard to raise the camera lens. Adjust the camera lens posi-
tion to provide the best viewing area for your installation.
VSC4S
Lens Adjustment