Filter
Top Products
31
EN
Make the settings for the functions while referring to “Using the Menu” (p. 3).
Erasing data completely
[ MEMORY FORMAT]/[ FORMAT]
x SETUP X MEMORY FORMAT/FORMAT
Before formatting, check that no important
data is left in the internal memory or card.
Non-Olympus cards and cards that have
been formatted by a computer must be
formatted with this camera before use.
Submenu 2 Application
YES
Completely erases the image data
in the internal memory
*1
or card
(including protected images).
NO Cancels formatting.
*1
Be sure to remove the card before formatting the
internal memory.
Copying images in the internal memory
to the card [ BACKUP]
x SETUP X BACKUP
Submenu 2 Application
YES
Backs up image data in the
internal memory to the card.
NO Cancels the backup.
It takes some time to back up data. Check
that the battery has suffi cient power before
starting the backup.
Changing the display language [W]
x SETUP X W
“Changing the display language” (p. 13)
Submenu 2 Application
Languages
*1
The language for the menus and
error messages displayed on the
monitor is selected.
*1
The available languages vary depending on the
country and/or region where the camera was
purchased.
Adjusting the CCD and the image
processing function [ PIXEL MAPPING]
x SETUP X PIXEL MAPPING
This function has already been adjusted
at factory shipping, and no adjustment is
needed right after purchase. Approximately
once a year is recommended.
For best results, wait at least one minute
after taking or viewing pictures before
performing pixel mapping. If the camera is
turned off during pixel mapping, be sure to
perform it again.
To adjust the CCD and to adjust the
image processing function
Press the B button when [START]
(Submenu 2) is displayed.
The camera checks and adjusts the CCD and the
image processing function at the same time.
Turning on the camera with the n/K
or q button [ Kn/q]
x SETUP X Kn/q
Submenu 2 Application
YES
Pressing n/K turns on the
camera and starts the camera in
the shooting mode.
Pressing q turns on the camera
and starts the camera in the
playback mode.
NO
The power is not turned on. To turn
on the camera, press the o
button.
●
Menus for Other Camera Settings
book_FE360_en.indb 31book_FE360_en.indb 31 6/23/2008 5:27:43 PM6/23/2008 5:27:43 PM