Filter
Top Products
5
Connection to a computer
When the USB cable is used to connect the camera to a computer, follow
the procedure below to select PC in the camera settings.
1 Insert the marked end of the provided USB cable into the
USB port on your computer as shown below.
• The location of the USB port varies depending on the computer.
For details, refer to your computer’s manual.
2 Set the camera’s mode dial to q.
3 Plug the other end of the USB
cable into the camera’s USB
connector.
4 Press the power switch to turn the
camera on.
5 The selection screen for the USB
connection (shown right) is
displayed on the monitor. Press
ac to select PC and press e.
6 The computer recognizes the
camera as a new device.
• When you connect the camera to the computer for the first time, the
computer automatically recognizes the camera. Click “OK” when the
message saying that the installation is completed appears.
• The computer recognizes the camera as a “Removable Disk”.
Look for this mark.
USB port
Terminal
Note
GO
SELECt
Power switch
Mode dial