Filter
Top Products
OPENING LEVERS
After unscrewing and pulling out the pressure release plug, the lid can be opened. To overcome the friction
of opening, two levers are used to push against the lid with a cam action. On some models these opening
levers are bolted to the body. On the other models, they are detachable levers.
Important!
Be sure they are inserted all the way flat to the housing
before turning to avoid damaging the protrusions on the
lid.
The body has two holes on opposite corner edges of the housing for opening. Gently lever off the lid with
the supplied cams taking care not to twist the lid excessively. The lid should be opened keeping it
approximately parallel to the body at all times. If using a single lever, turn first one side a little, then the
other an equal amount, and repeat again until the lid is opened.
Remember to unscrew and pull out the
pressure release plug all the way first, otherwise the air pressure will resist attempts at opening. Lay the lid
on a flat stable surface after opening.
Cam Levers Cam Lever in Housing
10