Filter
Top Products
E-4
3 Dismounting the PER-E01
ቢ
If any water is on the product, wipe it completely away and
make sure that the product is dry.
CAUTION: When removing the PPO-E series lens port and PER-E01 from the case, water drops on the
O-rings may splash on the lens or camera. If this happens, wipe the water drops away from
the lens and camera with a dry cloth.
Make sure that the PER-E01 is completely dry before dismounting.
ባ
Holding the PT-E series case firmly with one hand, loosen the
PPO-E series lens port that is attached to the PER-E01 by
turning the PPO-E about 90 degrees counterclockwise. If the
PPO-E is screwed in too tight, wrap it with a piece of rubber or
other slip-resistant material.
ቤ
After loosening the PPO-E series lens port, point its lens
down and turn it further counterclockwise until it is separated
from the PER-E01. Be careful not to drop the PPO-E, PER-
E01 or PT-E.
ብ
Holding the PT-E series case firmly with one hand, loosen the
PER-E01 by turning it about 90 degrees counterclockwise. If the
PER-E01 is screwed in too tight, wrap it with a piece of rubber or
other slip-resistant material.
ቦ
After loosening the PER-E01, point its lens down and turn it
further counterclockwise until it is separated from the PT-E
series case. Be careful not to drop the PER-E01 or PT-E.