Filter
Top Products
• High Voltage Pack HV-1
Indicator lamp
DC-IN terminal
Release lever
Connection
cable terminal
Power switch
Protective cap
storage position
Strap attaching
position
Belt loop
How to attach the strap
• Ni-Mh Battery Pack BN-1
Protective cap
Power indicator
lamp
Power indicator
button
• Always attach the
protective cap be-
fore storage.
• AC Adapter AC-2
Connection plug
AC power cord
• Plug the AC cord in firmly.
NK OK PK
1.
Remove the protective cap from the BN-1 Ni-Mh Battery Pack.
2. Set the HV-1 power switch to OFF.
NOTE:
If the battery pack is attached while the power switch is ON,
the indicator lamp blinks in red and the HV-1 does not function.
3.
Attach the BN-1 Ni-Mh Battery Pack to the HV-1 as described
below.
Align the groove at the bottom of the BN-1 Ni-Mh Battery Pack
with the claw on the lower part of the HV-1 and fit the upper part
of the BN-1 Ni-Mh Battery Pack into the release lever on the HV-
1 so that it clicks. Make sure the battery pack is attached firmly.
4. When detaching the BN-1 Ni-Mh Battery Pack, be sure to
set the power switch to OFF and then lift the release lever.
Recharging the battery pack
Attaching/detaching the battery pack
1
2
3
4
1
2
4
5
Remove the cover
before connection.
1. Set the HV-1 power switch to OFF/CHARGE.
(Charging is impossible if the power switch is set to ON.)
2. Push the BN-1 Ni-Mh Battery Pack power indicator button
and check the remaining battery capacity.
3. Attach the BN-1 Ni-Mh Battery Pack to the HV-1.
4. Connect the AC power cord to the input side of the AC-2
AC Adapter, and connect the other end of the AC power
cord to a power outlet.
5. Connect the connection plug of the AC-2 AC Adapter to
the DC-IN terminal of the HV-1. (Remove the terminal cover
before connection.)
6. Charging is complete when the indicator lamp on the HV-
1 lights in green.
Lamp Status Charging Status
Extinguished Battery not connected.
Red lighting Battery being charged.
Green lighting Battery charging completed.
Red blinking Charge error (Time-out or temperature error)
Notes
• New batteries or batteries that have not been used for a long time (more than one month) may not be fully charged. This is not
a malfunction, but is a characteristic of the battery. Charge them two or three times before using them for the first time or when
they have not been used for a long period.
• Once battery charging starts, it is recommended to continue charging until the battery has been fully charged, without stopping
charging in the middle. (The remaining battery capacity cannot be indicated correctly unless the battery is charged fully.)
• Whenever possible , use the battery until it has been fully discharged.
(Repeatedly recharging the battery before it has been fully used up may reduce the battery’s service life.)
• In the following cases, immediately unplug the power cord from the wall outlet and contact Olympus;
• if recharging does not complete in 10 hours;
• if the indicator lamp blinks in red while the battery pack is attached correctly as described in this manual.