Filter
Top Products
E-22
After sealing the Case, check that the camera functions normally.
ț Push the POWER button on the Case and confirm that the camera
turns ON/OFF.
ț Turn the mode dial knob on the Case and confirm that the camera
mode switches properly.
ț Push the shutter lever on the Case and confirm that the camera
shutter is released.
ț Operate other control buttons on the Case and confirm that the
camera functions as it should.
Check the camera operation.
:•If the camera does not function properly, restart the digital
camera installation procedure from “Check the digital
camera.” on page E-18 of this manual.
• Make sure that the mode dial can be moved after the
camera has been loaded in the Case. If the mode dial
does not move, there may be oil or grease on it; wipe it
clean.
•
When the digital camera is not used for about 3 minutes
while in the shooting mode, it enters the sleep mode
(standby status) and no operations are possible. To cancel
sleep mode and return to operation status, press the zoom
lever, shutter button or any other button. For details, refer to
the digital camera's instruction manual.
CAUTION
POWER Zoom
Mode
Shutter