ENGLISH
FRANÇAIS
ESPAÑOL
DS6639 Q.S.Guide-Eng/8 Lang. (086-003300- )
ENGLISH
FRANÇAIS
ESPAÑOL
Please read and carefully follow the user manual for instructions on connecting
the camera to your PC or macintosh.
BASIC PHOTOGRAPHY
QUICK START
1. Frame your subject in the viewfinder. You can also view the subject on the OSD.
2. Press the Shutter Release Button.
3. The image taken is displayed on the OSD for approximately a second (Auto
Review).
4. Once the Auto Review has finished, you may proceed to take the next picture.
When memory is full, no more images can be stored. The camera will
beep and the words “Internal Memory Full” or “Memory Card Full” will
appear on the LCD if you press the Shutter Release Button.
5. When you have finished taking your pictures, slide the Mode Switch to Off.
Connecting to PC
1. Hold the
camera firmly.
2. Avoid blocking
the lens and flash.
3. Do not move
nor remain in
motion while
taking pictures.
Preparing the Camera Holding the Camera
Taking Basic Pictures
1. Slide the Mode Switch to Camera Mode.
2. Press and hold the Power button to
turn the camera on.
3. Check the battery indicator, making
sure there is enough power.
Icon Description
Adequate power remains
Battery is running low
Battery is running very low.
Battery is exhausted.
4. Loop the strap over your wrist.
Inital Flash Settings
When you turn on your camera, the inital flash setting will vary depending on the
level of your battery.
Battery Status Initial Flash Setting
or The flash setting is saved after your camera is switched off
or the mode switch changes to another mode.
or The inital flash setting is . However, you can manually
set the flash to other settings.
Toggling Between Flash Modes
Flash Mode Options Table
Icon Function Description
Auto The flash may discharge automatically, depending on
the light conditions.
Flash On The flash discharges regardless of lighting condition.
Flash Off The flash will not discharge.
Selecting a Flash Mode
Press
Press
Press