Panasonic AG-DVC20P Camcorder User Manual


 
Before using
17
ª Selecting the remote control mode
If 2 cameras are used simultaneously, set the mode for one pair
of camera-recorder and remote control to [VCR1] and that of
the other pair to [VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When the coin-type
battery is replaced, the setting will revert to the default [VCR1].)
1 Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].
2 Setting on the remote control:
[VCR1]:
Press [D] and [] simultaneously. 1
[VCR2]:
Press [E] and [] simultaneously. 2
ª
Concerning the coin-type battery
When the coin-type battery runs down, replace it with a new
battery (part number: CR2025). The battery is normally
expected to last about 1 year, but it depends on operation
frequency.
Keep the coin-type battery out of the reach of children.
If the remote control mode of the camera and that of the
remote control do not match with each other, “REMOTE” will
appear. When the remote control is operated for the first time
after the camera is turned on, “CHECK REMOTE MODE”
(
-33-) will appear and operation is impossible. Set the same
remote control mode.
The remote control is intended for indoor operation. Outdoors
or under strong light, the camera-recorder may not operate
properly even within the usable ranges.
Within a 1 m (3 feet) range, you can operate the remote
control from beside the remote control sensor (LCD monitor
side) of the camera-recorder.
STOP
STILL ADV
VOL
PAUSE
STILL ADV
VAR
2 1
DVC20_Eng.book 17 ページ 2006年4月6日 木曜日 午前10時10分