VQT2G40 (ENG)
26
Basic
Note
•
The screen will change as following when the motion picture button is pressed in steps 3 and
4.
¢1 The screen that is displayed during motion picture mode setting is different depending on the
setting of the
[REC MODE].
¢2[!] will not be displayed in the Creative Motion Picture Mode.
Start recording by pressing the motion
picture button.
A Available recording time
B Elapsed recording time
• The audio is also recorded simultaneously from the
built-in microphone on this unit. (Motion pictures
cannot be recorded without audio.)
• The recording state indicator (red) C will flash while recording motion pictures.
• Focus can be achieved during recording by pressing [FOCUS].
Stop the recording by pressing the motion picture button again.
• Sound will go off when pressing the motion picture button indicating start/stop of motion
picture recording.
Sound volume can be set in [BEEP LEVEL].
• If the built-in memory or the card becomes full in the middle of recording, the camera
stops recording automatically.
A Still picture recording
screen
B Motion picture mode
setting
¢1
C Motion picture
recording screen
D Still picture mode
setting
¢2
55
R1m19sR1m19s
R1m19s
3s3s
3s
DMC-FZ38&FZ35P-VQT2G40_eng.book 26 ページ ２００９年６月３０日 火曜日 午後６時３３分
