Basic
- 34 -
Applicable modes:
Recording Motion Pictures
Note
•
Built-in memory can only store data as the [VGA] of [MP4].
• The available recording time displayed on the screen may not decrease regularly.
• Depending on the type of the card, the card access indication may appear for a while after
recording motion pictures. This is not a malfunction.
• Motion pictures cannot be recorded during [3D PHOTO MODE] in Scene Mode.
• ISO sensitivity will operate as [AUTO] in Motion Picture Recording other than Creative Video.
Also, [ISO LIMIT SET] will not function.
• There is a risk that the sound of zoom and button operations and the rubbing of the lens cap
string will be recorded, and so care is necessary.
• The screen may be blacked out momentarily, or the unit may record noise due to static
electricity or electromagnetic waves etc. depending on the environment of the motion picture
recording.
• When operating the zoom in recording motion pictures, it may take time to come into focus.
• If the Extended Optical Zoom was used before pressing the motion picture button, those
settings will be cleared, so the focus range will change dramatically.
• Even if the aspect ratio setting is the same in still and motion pictures, the angle of view may
change at the start of the motion picture recording.
When [ REC AREA] (P52) is set to [ON], angle of view during motion picture recording is
displayed.
• If you end motion picture recording after a short time when using [MINIATURE EFFECT] of the
Creative Control Mode, the camera may go on recording for a certain period. Please continue
to hold the camera until the recording finishes.
• It is recommended to use a fully charged battery or AC adaptor (optional) when recording
motion pictures.
• If while recording motion pictures using the AC adaptor and the power supply is cut off due to a
power outage or if the AC adaptor is disconnected etc., the motion picture being recorded will
not be recorded.
Start recording by pressing the motion picture
button.
A Available recording time
B Elapsed recording time
• You can record motion pictures fitting each Recording Mode.
• Release the motion picture button right after you press it.
• The recording state indicator (red) C will flash while recording
motion pictures.
• Focus can be achieved during recording by pressing [FOCUS].
• It is recommended that you close the flash when recording
motion pictures.
• For the setting of the [REC MODE] and [REC QUALITY], refer
to P123.
Stop the recording by pressing the motion picture
button again.
CUST
M
C
A
B