Filter
Top Products
VQT1U50
22
Preparation
Inserting/Removing the Battery
• Check that this unit is turned off.
• Close the flash.
Slide the release lever in the direction of the
arrow (OPEN side) and then open the battery
door.
• Always use genuine Panasonic batteries
(DMW-BLB13E).
• If you use other batteries, we cannot guarantee the
quality of this product.
Insert it fully being careful about the
direction you insert it. Pull the lever A in the
direction of the arrow to remove the battery.
1:Close the battery door.
2:Slide the release lever in the direction of
the arrow (LOCK side) and then close it
firmly.
Note
•
Remove the battery after use.
• Do not remove the battery while the power is on as the settings on the camera may not be
stored properly.
• The supplied battery is designed only for the camera. Do not use it with any other equipment.
• Before removing the battery, turn the camera off, and wait until the status indicator has gone off
completely. (Otherwise, this unit may no longer operate normally and the card itself may be
damaged or the recorded pictures may be lost.)