Filter
Top Products
VQT1U50
64
Advanced (Recording pictures)
[REC] mode:
Taking Pictures using Burst Mode
Pictures are taken continuously while the shutter button is pressed.
Select the ones you really like from among the pictures you have taken.
Set the drive mode lever to [ ].
Focus on the subject and take a picture.
A When burst mode is set to high speed [H].
• Hold down the shutter button fully to activate the
burst mode.
∫ Changing the burst speed
1 Select [BURST RATE] in the [REC] mode menu. (P27)
2 Press 3/4 to select the burst speed and then press
[MENU/SET].
3 Press [MENU/SET] to close the menu.
•
You can also press the shutter button halfway to close the menu.
¢1 Number of recordable pictures
¢2 Pictures can be taken until the capacity of the card becomes full. However the burst speed
will become slower halfway. The exact timing of this depends on the picture size, the setting
for the quality and the type of card used.
• First burst speed has no relation with the transfer speed of the card.
• The burst speed values given above apply when the shutter speed is 1/60 or faster and when
the flash is not activated.
• The burst mode speed may become slower depending on the following settings.
– [SENSITIVITY] (P79)/[PICTURE SIZE] (P98)/[QUALITY] (P99)/[FOCUS PRIORITY] (P107)/
Focus mode
• Refer to P99 for information about RAW files.
[H] (High speed) [L] (Low speed)
Burst speed (pictures/second) 32
¢
1
With RAW files max. 7
Without RAW files
Depends on the remaining capacity of the card
¢2
A