Filter
Top Products
- 108 -
Indication
Problem Check points
The remaining time
indication or the elapsed
time indication is not
shown.
≥ [DISPLAY] of the [SETUP] is [OFF]. (l 32)
Recording
Problem Check points
The unit arbitrarily stops
recording.
≥ Use an SD card that can be used for motion picture recording.
(l 16)
≥ The recordable time may have shortened due to the
deterioration of the data writing speed or repeated recording
and deletion. Using the unit, format the SD card or built-in
memory. (l 38)
≥ /
If [AGS] is [ON], record in the normal horizontal position or set
[AGS] to [OFF]. (l 50)
Auto Focus function does
not work.
≥ Switch to Intelligent Auto Mode.
≥ If you are trying to record a scene that is hard to bring into
focus in Auto Focus Mode, use the Manual Focus Mode to
adjust the focus. (l 27, 56)
“CONDITION TOO DARK,
OR OPEN LENS COVER.”
is displayed.
≥ Before turning on the unit, open the lens cover.
≥ This message may also be displayed when recording in a
very dark location.
Colour balance of images
is strange when recording
in a place such as a
gymnasium.
≥ In a place with multiple light sources, such as a gymnasium or
a hall, set the White Balance setting to (Indoor mode 2).
If you cannot record clearly with the (Indoor mode 2), set
it to (Manual adjustment mode). (l 54)
Colour or brightness of
the image changes, or you
may see horizontal bars in
the image.
The LCD monitor flickers
indoors.
≥ Colour or brightness of the image may change, or you may
see horizontal bars in the image when the object is recorded
under fluorescent light, mercury light or sodium light, etc., but
this is not a malfunction.
≥ Record in Intelligent Auto Mode or set the shutter speed to
1/100 in areas where the power supply frequency is 50 Hz, or
1/125 in areas of 60 Hz.