Filter
Top Products
– 65 –
AUDIO OUT SET UP menu
∑ Adjusting the audio output signals in relation to the video signals
(1) Press the F1 (A/V PHASE) key to put the display in reverse video.
(2) Adjust the phase difference using the ADJUST control.
When the ADJUST control is turned, the display changes to VAR.
(The adjustment can now be varied in 1-sample increments from i16 to j96 samples.)
(3) Upon completion of the adjustment, press the F1 (A/V PHASE) key.
≥When the UNITY/VAR key is pressed during the adjustment, the UNITY mode is restored.
≥When the key is pressed again, the mode reverts to VAR.
∑ Fade function
During editing, the cut-edited data is recorded automatically; during playback, this data is de-
tected and the section concerned is V-faded.
Playback V-fade function OFF Playback V-fade function ON
:
V-fading is performed for an instant to
eliminate the noise.
:
Noise appears at the joins in the editing.
Audio signal (A) Audio signal (B)
UNITY
A/V PHASE
ADJUST
VAR
i4
A/V PHASE
SAMPLES
UNITY
/VAR
Audio signal (A) Audio signal (B)