49
VQT1Y00
3 Open the LCD monitor.
The status indicator A lights red and the unit is
put into recording pause
≥ Quick Start Standby Mode is canceled if
jabout 5 minutes have elapsed
jmode is set to
junit is turned off
≥ Time for Quick Start will be more than 0.6
seconds slower when the digital cinema is
used.
≥ It may take some time for Automatic White
Balance to adjust.
≥ In the Quick start mode, the zoom
magnification becomes 1k.
≥ If [ECONOMY] (l 36) is set to [5 MINUTES]
and the unit automatically goes into Quick Start
Standby Mode, close the LCD monitor and
then open it again.
≥ Quick Start Standby Mode cannot be released
by the remote control. Turn the mode to OFF
when powering off.
(Only when recording to an SD card or built-
in memory)
The unit is put into recording pause approx.
1.9 seconds when the mode is set to from
OFF.
≥ Start time will not shorten if there is no SD card
inserted.
Start time will be shorten if the [Built-in
Memory] is selected in the [MEDIA SELECT],
even if there is no SD card inserted.
¬Change the mode to .
1
Select SD card as a media to
record from the menu. (l 34)
2 Select the menu. (l 34)
≥ This function’s default setting is [ON].
≥ In the Quick power on mode, the zoom
magnification becomes 1k.
HDC-SD20
HDC-TM20
HDC-HS20
Quick power on
[MEDIA SELECT] # [SD CARD]
[SETUP] # [QUICK POWER ON] # [ON]
HDCSD20&SD25&HS20P-VQT1Y00_eng.book 49 ページ 2008年12月22日 月曜日 午後8時16分